esphome:
  name: basement-sensor

esp8266:
  board: nodemcuv2

# Enable logging
logger:

# Enable Home Assistant API
api:
  # password: ""

ota:
  - platform: esphome
    password: ""

wifi:
  ssid: "Cochrun"
  password: "GreasyChicken784"
  manual_ip:
    static_ip: 192.168.1.122
    gateway: 192.168.1.1
    subnet: 255.255.255.0


  # Enable fallback hotspot (captive portal) in case wifi connection fails
  ap:
    ssid: "Basement Fallback Hotspot"
    password: "RUfAhbEfZmOU"

captive_portal:
    
web_server:
  port: 80   
  version: 3

http_request:
  verify_ssl: false

bluetooth_proxy:

i2c:
  sda: GPIO4
  scl: GPIO5
  scan: true
  id: bus_a

sensor:
  - platform: aht10
    variant: AHT20
    temperature:
      filters:
        offset: 1.3
      name: "Basement Room Temperature"
    humidity:
      name: "Basement Room Humidity"
    update_interval: 30s
    i2c_id: bus_a

# uart:
#   tx_pin: GPIO1
#   rx_pin: GPIO3
#   baud_rate: 115200

# sensor:
#   - platform: bme280_i2c
#     temperature:
#       name: "Temperature"
#       id: temperature
#       filters:
#         offset: -4.3
#       oversampling: 16x
#     pressure:
#       name: "Pressure"
#       id: pressure
#     humidity:
#       name: "Humidity"
#       id: humidity
#     i2c_id: bus_a
#     address: 0x76

# dfrobot_sen0395:

# binary_sensor:
#   # Information coming from uart bus
#   - platform: dfrobot_sen0395
#     name: Mmwave UART

#     # on_...:
#     #   - dfrobot_sen0395.settings:
#     #       factory_reset: true
#     #       detection_segments:
#     #         # Define between one and four segments
#     #         - [0cm, 3m]
#     #         - [5.1m, 6.6m]
#     #         output_latency:
#     #           delay_after_detect: 0s
#     #           delay_after_disappear: 0s
#     #           sensitivity: 7

#   # Information coming from dedicated gpio (IO2)
#   - platform: gpio
#     name: Mmwave GPIO
#     device_class: motion
#     pin:
#       number: GPIO16
#       mode: INPUT_PULLDOWN

# switch:
#   # Switch to turn on/off detection
#   - platform: dfrobot_sen0395
#     type: sensor_active
#     name: Mmwave Active

#   - platform: dfrobot_sen0395
#     type: presence_via_uart
#     name: Mmwave UART active
#     restore_mode: always_on

#   - platform: dfrobot_sen0395
#     type: turn_on_led
#     name: Mmwave Led
#     restore_mode: always_off
#     icon: "mdi:led-on"

#   - platform: dfrobot_sen0395
#     type: start_after_boot
#     name: Mmwave Start
#     restore_mode: always_on